Owner Driver Magazine · Regulatory Guidance · 12 November 2026
Heavy vehicle caught with speed limiter set to 127km/h as tampering persists
A heavy vehicle was intercepted with its speed limiter set to 127km/h during Operation Quicksilver, a national operation earlier this year targeting speeding and speed limiter interference in which more than 2,000 heavy vehicles were intercepted. The driver was issued a compliance notice and two critical fatigue offences for exceeding prescribed driving hours and failing to take sufficient rest. All of the vehicle's trailers had brake defects. The Queensland-based operator received major and minor defect notices for brake and speed limiter non-compliance. By contrast, Kerden Haulage owner Damien Radburn fitted tamper-evident security tags to the speed limiters on his 20 prime movers after a driver was caught with an altered limiter two years ago. Two of his vehicles were intercepted with no issues detected.
Why it mattersLimiter tampering rarely travels alone. This interception also produced critical fatigue offences and brake defects on every trailer, which points to a system failure rather than one driver's choice. NHVR chief operations officer Paul Salvati held up the Kerden Haulage tags as the standard the regulator wants: an operator identifying the problem and fitting a physical control that makes interference evident.
What to do
Fleet maintenance should inspect the speed limiter setting and any tamper-evident tag on every prime mover, under the HVNL primary duty and the vehicle standards element of the SMS. Record the set speed against the 100km/h limit and refer any broken or absent tag to the compliance function for investigation.
A dated limiter check register per prime mover, naming who checked, the set speed read, the tag sighted and the method used.
11 fatigue matters recorded on the register this year; median fine $12,730. See the register →